1887
Volume 29, Issue 3-4
  • ISSN: 0812-3985
  • E-ISSN: 1834-7533

Abstract

Controlled source audio-frequency magnetotelluric (CSAMT) surveys have found frequent application in mineral exploration, and there have also been a number of attempts to use magnetotelluric (MT) soundings in the same application. The advantages of CSAMT over conventional electromagnetic methods lies in its ability (through measurements of the electric field) to discriminate resistive as well as conductive zones, and in its depth-of-penetration capability.

“Static shift” however can be a common problem in many MT and CSAMT soundings. It severely distorts any depth calculations and degrades the resolution of conductivity structure inferred from scalar CSAMT measurements. Static shift also significantly restricts the MT-method in its use for geological studies of the upper and lower crust; and its application to mineral, hydrocarbon, and geothermal resource exploration. Theoretical investigation using modelling has shown that measurements of an Inductive Source Telluric Field (ISTF) may closely predict and thus potentially remove the static shift at MT and CSAMT stations.

Applications of the method in the field require the additional setup of a low-power transmitter near the survey line. The main survey electrodes, cables and receiver are then used to collect additional data for corrections. This process can be run in parallel with the MT or CSAMT data acquisition, and requires little additional survey time. Initial tests of the concept in field studies near Sydney and over a skarn prospect in the Parkes vicinity proved very encouraging. The ‘along-line variation’ indicative of static shift was reduced by the correction by a factor of about 5 in the Parkes case, and the ‘corrected’ CSAMT section appeared smooth and regular as opposed to having the vertical striping typical of static problems.

© 1998 ASEG
Loading

Article metrics loading...

/content/journals/10.1071/EG998494
1998-09-01
2026-01-21

  • From This Site

    /content/journals/10.1071/EG998494
    dcterms_title,dcterms_subject,pub_keyword
    -contentType:Journal -contentType:Contributor -contentType:Concept -contentType:Institution
    10
    5
Loading full text...

Full text loading...

References

  1. Bostick, F.X., 1986 Electromagnetic array profiling (EMAP), SEG 56th Ann. Int. Mtg. Exp. Abs;, 60–61.
  2. Goldberg, S. and Rostein, Y., 1982. A simple form of presentation of magnetotelluric data using the Bostick transform, Geophys. Prospecting, 30, 211–216.
  3. Jiracek, G., 1990. Near-surface and topographic distortions in electromagnetic induction, Surveys in Geophysics, 11: 163–203.
  4. Jones, A. G., 1988. Static shift of magnetotelluric data and its removal in a sedimentary basin environment, Geophysics, 53, 968–978.
  5. Kurtz, R.D., Craven, J. A., Niblett, E. R. and Steven, R. A., 1993. The conductivity of the crust and mantle beneath the Kapuskasing Uplift: Electrical anisotropy in the upper mantle, Geophys. J. Int., 113, 483–498.
  6. Lay, L., 1997. Investigation of a new technique for the correction of static shift in magnetotelluric soundings. Honours thesis, Cooperative Research Centre for Australian Mineral Exploration Technologies, Macquarie University, Sydney NSW.
  7. Lin, Z., 1996. 2.5D modelling and inversion of deep transient electromagnetic soundings with a grounded source. PhD thesis, Macquarie University, Sydney, NSW.
  8. Lu, K., 1998. Efficient induced polarisation and resistivity methods. PhD thesis, Macquarie University, Sydney, NSW.
  9. Macnae, J., 1981. Geophysical prospecting using electric fields from an inductive EM source, Research in Applied Geophysics 18, University of Toronto, 218pp.
  10. Pellerin, L. and Hohmann, G. W., 1990. Transient electromagnetic inversion: A remedy for magnetotelluric static shifts, Geophysics, 55, 1242–1250.
  11. Raiche, A. R, Jupp, D. L. B., Rutter, H. and Vozoff, K., 1985. The joint use of coincident loop transient electromagnetic and Schlumberger sounding to resolve layered structures. Geophysics 50, 1618–1627.
  12. Singer, B. Sh. and Fainberg, E. B., 1985. Electromagnetic induction in non-uniform thin sheets. M. IZMIRAN, 234p.
  13. Singer, B. SH., 1995. Method for solution of Maxwell’s equations in non-uniform media. Geophys. J., Int., 120, 590–598.
  14. Sternberg, B. K., Washburne, J. C., and Pellerin, L., 1988. Correction for the static shift in magnetotellurics using transient electromagnetic soundings, Geophysics, 53, 1459–1468.
  15. Tattersall, L. 1997. Improvement of electric field measurements in magnetotelluric and controlled source audio-frequency magnetotelluric soundings. Honours thesis, Cooperative Research Centre for Australian Mineral Exploration Technologies, Macquarie University, Sydney, NSW.
  16. Vozoff, K., 1991. The magnetotelluric method, in: Electromagnetic methods in applied geophysics, Volume 2, Part B, ed: M. N. Nabighian, 641–711, Society of Exploration Geophysicists, Tulsa, Oklahoma.
  17. Vozoff, K., Engels, O. G., Poole, G., and Lintker, S., 1996 German-Australian demonstrations of LOTEM measurements in coal. Unpublished.
  18. Zhdanov, M. S. and Keller, G. V., 1994. The geoelectrical methods in geophysical exploration. Elsevier Science: The Netherlands.
/content/journals/10.1071/EG998494
Loading
  • Article Type: Research Article
Keyword(s): CSAMT; Electromagnetic surveys; Magnetotelluric; MT; Static shift correction

Most Cited This Month Most Cited RSS feed

This is a required field
Please enter a valid email address
Approval was a Success
Invalid data
An Error Occurred
Approval was partially successful, following selected items could not be processed due to error