Basin Research - Volume 13, Issue 4, 2001

ABSTRACT The tectonic evolution of a collisional hinterland sourcing the Ha?eg Basin, a Late Cretaceous syn‐orogenic sedimentary basin in the South Carpathians (Romania), is revealed through fission track thermochronology of detrital apatite and zircon grains. This basin formed on the upper plate (Getic unit) in response to Late Cretaceous collision with the lower plate (Danubian unit), an allochtonous continental block of the Moesian Platform, upon closure of a narrow oceanic basin (Severin Basin). The fission track results suggest that Turonian to lower Maastrichtian sediments of the Ha?eg Basin have been dominantly derived from pre‐Late Cretaceous sources. The age components they contain relate to pre‐Cretaceous tectonothermal events such as the Variscan orogenic cycle, Jurassic rifting and Severin Basin formation, and to Early Cretaceous compressional tectonics. These results are compatible with the tectonic evolution of the upper plate that is identified as the primary source. From the onset of sedimentation (late Albian) until the early Campanian the Ha?eg Basin resembles a piggy‐back basin formed on the upper plate concomitant with underthrusting and internal stacking of the lower plate. In contrast, important tectonic subsidence during the late Campanian and early Maastrichtian reflects a shift to extensional tectonics causing the unroofing of the collision zone and the exhumation of lower plate rocks back to the surface. Our fission track data place important constraints on the timing of lower plate erosion that must have commenced during the late Maastrichtian, as documented by the completely reset Late Cretaceous age component within upper Maastrichtian sediments (Sînpetru Formation). Late Maastrichtian uplift of the basin and the formation of positive relief at the site of the collision zone is an expression of continuous convergence. The mismatch between the amount of denudation and the amount of sediments trapped in the Ha?eg Basin underlines the importance of concomitant extensional unroofing.

ABSTRACT From study of Palaeozoic formations in the Appalachian foreland basin, a predictive stratigraphic model is proposed based on facies tract development during convergent‐margin structural evolution. Five major facies tracts are recognized: shallow‐water carbonates that formed during interorogenic quiescence and initial foreland subsidence; deep‐water siliciclastics that accumulated in the proximal foreland basin during early collision; syn‐collisional shallow‐water siliciclastics; syn‐collisional, channellized fluvial sandstones that aggraded in the proximal foreland; and progradational shoreline sandstones that were deposited in response to filling of the proximal foreland. Two other facies tracts that occur are organic‐rich siliciclastics (‘black shales’), which accumulated in oxygen‐deficient areas of low clastic‐sediment influx, and incised valley‐fill deposits, which formed where subsidence rate was low.

Because the origin of each facies tract is dependent upon a unique combination of rate of accommodation change and rate of sediment supply, facies tract distribution is predictable from spatial and temporal patterns of subsidence and uplift associated with plate convergence. Alternating phases of thrust loading and quiescence caused fluctuations between underfilled and overfilled conditions during Palaeozoic evolution of the Appalachian basin. Along‐strike variations in stratigraphic thickness, facies tract distribution, and development of unconformities in the Appalachian basin reflect the influence of structural irregularities along the collisional margin. In distal parts of the Appalachian foreland and in areas of structural recesses, eustatic influence on stratigraphic patterns is expressed more clearly than in areas of higher subsidence rate.

ABSTRACT During the Eocene in the Corbières–Minervois foreland basin, southern France, there was a transition from marine carbonate to fluvial–lacustrine sedimentation. This evolution took place in six depositional sequences, the first controlled by a eustatic rise or flexural downwarping, then following under compressive tectonic conditions. The second to the fourth sequences show marine to marshy, mainly carbonate sediments with a transgressive–regressive evolution, while the last two comprise terrigenous and carbonate continental sediments. The tectonic evolution is marked by blind fault‐propagation folds which deformed the basin during the Ilerdian–Cuisian. A paroxysmal compressive tectonic phase occurred at the Bartonian when the ancient blind thrusts started to emerge. A model for the evolution of the basin is presented, involving the northward propagation of structural culminations, which focused shallow water or emergent conditions, and structural lows in which deeper water sedimentation took place. The diachronous migration of these structural zones can be constrained from the high biostratigraphic resolution of the foreland basin fill.

ABSTRACT Apatite fission track ages of 20 samples collected from turbidite successions deposited in foreland basins adjacent to the Northern Apennines range between ∼3 and ∼10 Ma. The youngest fission track ages are concentrated in a NW–SE elongated belt, which approximately runs through the centre of the study area, while gradually increasing ages are distributed towards the south‐western and north‐eastern borders. Integration of apatite fission track data and published vitrinite reflectance values indicate this region of the Apennines experienced continuous but variable exhumation starting from ∼14 Ma. The extent of exhumation and uplift range between 5 and 6 km at the south‐western and north‐eastern borders of the study area, and ∼7 km in the central part. Exhumation was driven mainly by erosion, with minor faulting in response to structural readjustment related to differential exhumation. Regional exhumation and erosion are interpreted as the result of isostatic rebound following crustal thickening in the lower part of the orogen.

ABSTRACT The Dehradun Valley, a synclinal intermontane valley piggyback basin within the Siwalik Group rocks in the NW Himalaya, is separated from the Lesser Himalayan formations in the north by a major intraplate thrust, the Main Boundary Thrust (MBT) and from the Indogangetic Plains in the south by the Himalayan Frontal Fault (HFF). Major parts of the Dehradun Valley are covered by three fans, from west to east the Donga, Dehradun and Bhogpur fans, deposited by streams following the topography produced by activity of the MBT and probable footwall imbricate thrusts, starting at about 50 ka.

The Donga and Dehradun fans were fed by small streams and characterized mainly by sediment gravity‐flow deposits (debris flow and mudflow deposits) in the proximal zone, and mostly mudflow deposits and minor braided stream deposits in the middle zone during the period 50–10 ka. Palaeosols were weakly developed in the proximal zone and moderately to strongly developed in the middle zone. The degree of development of palaeosol was mainly a function of rate of sedimentation and to some extent entrenchment of streams into the fan surface. Since 10 ka, deposition has been typically by braided streams. The Bhogpur fan has been marked by deposition from relatively larger braided streams since 50 ka.

The fan sequences in the Dehradun Valley are synorogenic and their deposition started due to activity of the southern footwall imbricate of the MBT, i.e. Bhauwala Thrust on the Donga and Dehradun fans. In these fans, major fan sequences show retrogradation (50–10 ka) related to a decrease in the activity of the MBT and related imbricates and activity of more hinterlandward imbricates with time. After 10 ka a thin prograding sequence was deposited due to uplift of the fans, which resulted from the activity on a thrust in the distal parts of the fans. It suggests an out‐of‐sequence activity of faults in the MBT imbricate system. Cross‐faults divide the Siwalik formations in the footwall of the MBT into three blocks, which were marked by decreasing subsidence or possibly uplift from east to west. Thrusting on the HFF was not piggyback type but synchronous with activity of the MBT and its imbricates. The development of the Mohand fault‐bend anticline above the HFF changed the nature of the basin from foreland to piggyback type, shed minor colluvial deposits prior to 10 ka, and folded the southernmost fan deposits in the western, narrow parts of the valley.

A major change in climate from a cold, dry climate with strong seasonal variations prevailing since 50 ka to warm and humid climate at about 10 ka resulted in a change in depositional processes from sediment gravity‐flows to braided streams.