Basin Research - Volume 24, Issue 1, 2012

The terrigeneous sediment budget of passive margin basins records variations in continental relief triggered by either deformation or climate. Consequently, it becomes a major challenge to determine sediment accumulation histories in a large number of basins found in various geodynamic contexts. In this study, we developed a GIS‐based method to determine the sediment budget at the scale of a whole basin (from the upstream continental onlap to the most distal deepest marine deposits) and the associated uncertainties. The volume of sediments preserved in the basin for each time interval was estimated by interpolation between cross‐sections and then corrected from in situ production and porosity to obtain terrigeneous solid volumes. This approach was validated by applying it to Namibia–South African passive margin basins for which independent data are available. We determined by a statistical approach the variances associated with each parameter of the method: the geometrical extrapolation of the section (8–43%), the uncertainties on seismic velocities for the depth conversion (2–10%), on the absolute ages of stratigraphic horizons (0.2–12%), on the carbonate content (0.2–46%) and on remaining porosities estimation (3–5%). Our estimates of the accumulated volumes were validated by comparison with previous estimates at a lower temporal resolution in the same area. We discussed variations in accumulation rates observed in terms of relief variations triggered by climate and/or deformation. The high accumulation rates determined for the Lower Cretaceous, progressively decreasing to a minimum in the Mid‐Cretaceous, are consistent with the progressive relaxation of a rift‐related relief. The following increase to an Upper Cretaceous maximum is consistent with a major relief reorganization driven either by an uplift and/or a change to more humid climate conditions. The lower accumulation rate in the Cenozoic suggests a relief reorganization of lesser amplitude over that period.

Magnetostratigraphy of sedimentary rock deposited in the Chaka basin (north‐eastern Tibetan Plateau) indicates a late Miocene onset of basin formation and subsequent development of the adjacent Qinghai Nan Shan. Sedimentation in the basin initiated at ∼11 Ma. In the lower part of the basin fill, a coarsening‐upward sequence starting at ∼9 Ma, as well as rapid sedimentation rates, and northward paleocurrents, are consistent with continued growth of the Ela Shan to the south. In the upper section, several lines of evidence suggest that thrust faulting and topographic development of the Qinghai Nan Shan began at ∼6.1 Ma. Paleocurrent indicators, preserved in the basin in the proximal footwall of the Qinghai Nan Shan, show a change from northward to southward flow between 6.5 and 3.8 Ma. At the same location, sediment derived from the Qinghai Nan Shan appears at 6.1 Ma. Finally, the initiation of progressively shallowing dips observed in deformed basin strata and a change to pebbly, fluvial deposits at 6.1 Ma provide a minimum age for the onset of slip on the thrust fault that dips north‐east beneath the Qinghai Nan Shan. We interpret a decrease in sediment accumulation rates since ∼6 Ma to indicate a reduction in Chaka basin accommodation space due to active faulting and folding along the Qinghai Nan Shan and incorporation of the basin into the wedge‐top depozone. Declination anomalies indicate the beginning of counter‐clockwise rotation since 6.1 Ma, which we associate with local deformation, not regional block rotation. The emergence of the Qinghai Nan Shan near the end of the Miocene Epoch partitioned the once contiguous Chaka‐Gonghe and Qinghai basin complex. In a regional framework, our study adds to a growing body of evidence that points to widespread initiation and/or reactivation of fault networks during the late Miocene across the north‐eastern Tibetan Plateau.

Quantifying the Cenozoic growth of high topography in the Indo‐Asian collision zone remains challenging, due in part to significant shortening that occurred within Eurasia before collision. A growing body of evidence suggests that regions far removed from the suture zone experienced deformation before and during the early phases of Himalayan orogenesis. In the present‐day north‐eastern Tibetan Plateau, widespread deposits of Cretaceous sediment attest to significant basin formation; however, the tectonic setting of these basins remains enigmatic. We present a study of a regionally extensive network of sedimentary basins that are spatially associated with a system of SE‐vergent thrust faults and are now exposed in the high ranges of the north‐eastern corner of the Tibetan Plateau. We focus on a particularly well‐exposed basin, located ∼20 km north of the Kunlun fault in the Anyemaqen Shan. The basin is filled by ∼900 m of alluvial sediments that become finer‐grained away from the basin‐bounding fault. Additionally, beds in the proximal footwall of the basin‐bounding fault exhibit progressive, up‐section shallowing and several intraformational unconformities which can be traced into correlative conformities in the distal part of the basin. The observations show sediment accumulated in the basin during fault motion. Regional constraints on the timing of sediment deposition are provided by both fossil assemblages from the Early Cretaceous, and by K–Ar dating of volcanic rocks that floor and cross‐cut sedimentary fill. We argue that during the Cretaceous, the interior NE Tibetan Plateau experienced NW–SE contractional deformation similar to that documented throughout the Qinling–Dabie orogen to the east. The Songpan‐Ganzi terrane apparently marked the southern limit of this deformation, such that it may have been a relatively rigid block in the Tibetan lithosphere, separating regions experiencing deformation north of the convergent Tethyan margin from regions deforming inboard of the east Asian margin.

[Correction added after online publication 3 August 2010 ‐ ‘prelate’ has been changed to ‘pre‐late’ throughout the text]. Using apatite fission track and (U‐Th‐Sm)/He thermochronology, we report the low‐temperature thermal history of the Mesozoic Micang Shan Foreland Basin system, central China. This system, comprising the Hannan Dome hinterland, the northern Sichuan Foreland Basin and the intermediate frontal thrust belt (FB), shares a common boundary with three major tectonic terrains – Mesozoic Qinling‐Dabie Orogen, Mesozoic Sichuan Foreland Basin and Cenozoic elevated Tibetan Plateau. Results show: (1) a relatively rapid pre‐late Cretaceous cooling episode in the Hannan Dome; (2) a mid‐Cenozoic cooling phase (ca. 50°C at ca. 30 ± 5 Ma) within the northern Sichuan Basin; and (3) possible late Cenozoic cooling (ca. 25°C at ca. 16 ± 4 Ma) within the Hannan Dome‐FB, a phase which has also been reported previously from adjacent regions. The pre‐late Cretaceous cooling episode in the Hannan Dome is attributed to coeval tectonism in nearby regions. Mid‐Cenozoic cooling in the northern Sichuan Basin can possibly be attributed to either one of or a combination of shortening of the basin, onset of the Asian monsoon and drainage adjustment of the Yangtze River system, all of which are related to growth of the Tibetan Plateau. Possible late Cenozoic cooling in the hinterland and nearby regions is also probably related to the northeastward growth of the Tibetan Plateau. However, previous studies suggest a northeastward propagation for onset of cooling from the eastern Tibetan Plateau to western Qinling in response to northeastward lower crust flow from the central Tibetan Plateau. The timing of apparent late Cenozoic cooling in the Hannan Dome hinterland, at an intermediate locality, is not consistent with this trend, and supports a previous model suggesting northeastern growth of the Tibetan Plateau through reactivation of WE trending strike‐slip faults.

Detailed seismic stratigraphic analysis of 2D seismic data over the Faroe‐Shetland Escarpment has identified 13 seismic reflection units that record lava‐fed delta deposition during discrete periods of volcanism. Deposition was dominated by progradation, during which the time shoreline migrated a maximum distance of ∼44 km in an ESE direction. Localised collapse of the delta front followed the end of progradation, as a decrease in volcanic activity left the delta unstable. Comparison with modern lava‐fed delta systems on Hawaii suggests that syn‐volcanic subsidence is a potential mechanism for apparent relative sea level rise and creation of new accommodation space during lava‐fed delta deposition. After the main phase of progradation, retrogradation of the delta occurred during a basinwide syn‐volcanic relative sea level rise where the shoreline migrated a maximum distance of ∼75 km in a NNW direction. This rise in relative sea level was of the order of 175–200 m, and was followed by the progradation of smaller, perched lava‐fed deltas into the newly created accommodation space. Active delta deposition and the emplacement of lava flows feeding the delta front lasted ∼2600 years, although the total duration of the lava‐fed delta system, including pauses between eruptions, may have been much longer.

We use three‐dimensional (3D) seismic reflection data to analyse the architecture of the footwall of a listric fault, in a gravitationally driven extensional system, in the north‐western Niger Delta. In contrast to conventional listric normal fault models with a single master listric fault plane the level of detachment switches from a deeper to shallower level. The footwall evolves through the generation of new master detachment faults and detachments, which transfers hanging wall rocks into the footwall. New detachments form by branching off pre‐existing detachment levels, cutting‐up through stratigraphy to the next mechanical weakness, separating discrete sections of extended strata. As a consequence a deeper, older array of seaward‐dipping, tilted extensional fault blocks is now located in the footwall beneath the master listric detachment fault. The structural complexity located below the master detachment fault highlights extensional episodes on separate detachment faults that are not captured in conventional listric models. We speculate that changes in the level of the detachment are caused by mechanical weaknesses controlled by lithology, pore pressure and episodes of sediment loading related to deltaic progradation.