Basin Research - Volume 25, Issue 1, 2013

The Corinth rift (Greece) is one of the world's most active rifts. The early Plio‐Pleistocene rift is preserved in the northern Peloponnese peninsula, south of the active Corinth rift. Although chronostratigraphic resolution is limited, new structural, stratigraphic and sedimentological data for an area >400 km² record early rift evolution in three phases separated by distinct episodes of extension rate acceleration and northward fault migration associated with major erosion. Minimum total N–S extension is estimated at 6.4–7.7 km. The earliest asymmetrical, broad rift accommodated slow extension (0.6–1 mm a⁻¹) over >3 Myrs and closed to the west. North‐dipping faults with throws of 1000–2200 m defined narrow blocks (4–7 km) with little footwall relief. A N‐NE flowing antecedent river system infilled significant inherited relief (Lower group). In the earliest Pleistocene, significant fluvial incision coincided with a 15 km northward rift margin migration. Extension rates increased to 2–2.5 mm a⁻¹. The antecedent rivers then built giant Gilbert‐type fan deltas (Middle group) north into a deepening lacustrine/marine basin. N‐dipping, basin margin faults accommodated throws <1500 m. Delta architecture records initiation, growth and death of this fault system over ca. 800 ka. In the Middle Pleistocene, the rift margin again migrated 5 km north. Extension rate increased to 3.4–4.8 mm a⁻¹. This transition may correspond to an unconformity in offshore lithostratigraphy. Middle group deltas were uplifted and incised as new hangingwall deltas built into the Gulf (Upper group). A final increase to present‐day extension rates (11–16 mm a⁻¹) probably occurred in the Holocene. Fault and fault block dimensions did not change significantly with time suggesting control by crustal rheological layering. Extension rate acceleration may be due to strain softening or to regional tectonic factors.

The Crotone Basin was generated in the late Cenozoic as a forearc basin of the Ionian arc‐trench system. New data are gained through detailed field mapping, high‐resolution stratigraphic analysis of a key area and examination of offshore well data and seismic reflection profiles. Major unconformities divide the basin fill into major sequences, which reveal a three‐stage internal organization thought to reflect geodynamic events of the Calabrian arc and backarc area closely. The first stage is characterized by extensional block faulting and uplift followed by rapid drowning during high subsidence and transtension in the basin along a major NNW‐ to NW‐striking fault system. This stage is interpreted to reflect resumption of rollback after an episode of slab tearing triggered by transitory docking of continental lithosphere in the trench. The initial uplift is inferred to reflect decoupling and rebound after the transitory coupling phase. The second stage is characterized by increased subsidence and continued extension/transtension. This trend presumably reflects a decreasing rate of rollback resulting from a tendency towards viscous coupling after acceleration of slab downwelling. The third stage is characterized by short‐lived transpression along major shear zones and local inversion of former basins. This is inferred to reflect entrance into the trench of buoyant continental lithosphere, resulting in significant deceleration of slab rollback and consequently a break in, or slowing of, backarc extension, and predominance of the effects of compression related to Africa–Europe convergence. Overall, the above evolution resulted in the formation of a progressively narrower and rapidly retreating slab, inducing extreme rates of backarc extension, and may have played a critical role in determining the intermittent nature of the backarc rifting.

The Murzuq Basin is one of the most petroliferous basins of North Africa. Its remote eastern flank has been largely ignored since early reconnaissance work in the 1950s and 1960s. This article presents new stratigraphic and sedimentological data on the Neoproterozoic through Devonian succession from the Mourizidie and Dor el Gussa regions. The Neoproterozoic to Cambrian Mourizidie and Hasawnah formations in the eastern part of the Mourizidie region dip to the east and north‐east, resting directly on late Precambrian metasediments and granitoids. These strata record the initial progradation of sand‐dominated braidplain systems upon peneplained Precambrian basement. Rhyolite clasts in the Hasawnah Formation may record tectonically driven uplift and unroofing in the southern Tibesti Massif or tectonomagmatic rejuvenation to the south of this massif. In the western part of the Mourizidie region, Late Ordovician through Silurian strata (Mamuniyat and Tanezzuft–Akakus formations) directly overlie late Precambrian metasediments and granitoids, and dip at a low angle towards the west into the Murzuq Basin. Elsewhere at the eastern Murzuq Basin flank, in Dor el Gussa, Late Ordovician glaciogenic sediments rest with angular unconformity upon shallow marine sandstones of Cambrian–Ordovician age. This angular unconformity may also occur in the Mourizidie region and indicates widespread tectonism, either as a result of a Middle–Late Ordovician orogenic event, far‐field tectonism related to the opening of the Rheic Ocean along the northern margin of Gondwana or alternatively crustal depression associated with the growth of Late Ordovician ice sheets. Unconformity development was also probably associated with glacial incision. Following ice sheet retreat, isostatic rebound during deglaciation resulted in uplift of tens to hundreds of metres, locally removing all Cambrian and Ordovician formations. Rising sea levels in the Silurian led to deposition of the Tanezzuft Formation on Precambrian basement in the northwestern Mourizidie region.

The Xunhua, Guide and Tongren intermontane basin system in the NE Tibetan Plateau, situated near the Xining basin to the N and the Linxia basin to the E, is bounded by thrust fault‐controlled ranges. These include to the N, the Riyue Shan, Laji Shan and Jishi Shan ranges, and to the S the northern West Qinling Shan (NWQ). An integrated study of the structural geology, sedimentology and provenance of the Cenozoic Xunhua and Guide basins provides a detailed record of the growth of the NE Tibetan Plateau since the early Eocene. The Xining Group (ca. 52–21 Ma) is interpreted as consisting of unified foreland basin deposits which were controlled by the bounding thrust belt of the NWQ. The Xunhua, Guide and Xining subbasins were interconnected prior to later uplift and damming by the Laji Shan and Jishi Shan ranges. Their sediment source, the NWQ, is constrained by strong unidirectional paleocurrent trends towards the N, a northward fining lithology, distinct and recognizable clast types and detrital zircon ages. Collectively, formation of this mountain–basin system indicates that the Tibetan Plateau expanded into the NWQ at a time roughly coinciding with Eocene to earliest Miocene continental collision between India and Eurasia. The Guide Group (ca. 21–1.8 Ma) is inferred to have been deposited in the separate Xunhua, Guide and Tongren broken foreland basins. Each basin was filled by locally sourced alluvial fans, braided streams and deltaic‐lacustrine systems. Structural, paleogeographic, paleocurrent and provenance data indicate that thrust faulting in the NWQ stepped northward to the Laji Shan from ca. 21 to 16 Ma. This northward shift was accompanied by E–W shortening related to nearly N–S‐striking thrust faulting in Jishi Shan after 11–13 Ma. A lower Pleistocene conglomerate (1.8–1.7 Ma) was deposited by a through‐flowing river system in the overfilled and connected Guide and Xunhua basins following the termination of thrust activity. All of the basin–mountain zones developed along the Tibetan Plateau's NE margin since Indian–Tibetan continental collision may have been driven by collision‐induced basal drag of old slab remnants in the manner of N‐dipping and flat‐slab subduction, and their subsequent sinking into the deep mantle.

In this article, we document a large number of focused fluid escape structures using high quality 2D seismic reflection data and multibeam bathymetry data from a poorly known area at the intersection of the northern South China Sea (SCS) and the western SCS. Three types of focused fluid escape systems are identified and described: mud volcanoes, pipes and associated pockmarks. The mud volcanoes occur singly or as clustered groups. The overpressure driving the mud volcanism is argued herein to be related to the generation of thermogenic hydrocarbons. The clustered distributions are related to localized tectonic uplift in the basin. Pipes mainly occur within the Guangle Uplift or accompany the mud volcano clusters. The pipes located within the Guangle Uplift are attributed to carbonate dissolution caused by hydrothermal fluids. Fluids ascended through these structures and were expelled at the palaeo‐seabed or present seabed forming palaeo‐pockmarks and present‐day pockmarks. Some ‘mega‐pockmarks’ show evidence of enlargement due to bottom currents. The marginal basins of the SCS are petroliferous, with attention gradually shifting to the deep‐water area. Our results show that fluid migration must be taken into account when assessing seabed stability. This analysis also improves our understanding the petroleum geology in the study area, and is also useful for predicating where chemosynthetic ecosystems may be located.