- Home
- A-Z Publications
- Petroleum Geoscience
- Previous Issues
- Volume 27, Issue 4, 2021
Petroleum Geoscience - Volume 27, Issue 4, 2021
Volume 27, Issue 4, 2021
-
-
Intra-salt structure and strain partitioning in layered evaporites: implications for drilling through Messinian salt in the eastern Mediterranean
Authors Sian L. Evans and Christopher A.-L. JacksonWe use 3D seismic reflection data from the Levant margin, offshore Lebanon to investigate the structural evolution of the Messinian evaporite sequence, and how intra-salt structure and strain varies within a thick salt sheet during early-stage salt tectonics. Intra-Messinian reflectivity reveals lithological heterogeneity within the otherwise halite-dominated sequence. This leads to rheological heterogeneity, with the different mechanical properties of the various units controlling strain accommodation within the deforming salt sheet. We assess the distribution and orientation of structures, and show how intra-salt strain varies both laterally and vertically along the margin. We argue that units appearing weakly strained in seismic data may in fact accommodate considerable subseismic or cryptic strain. We also discuss how the intra-salt stress state varies through time and space in response to the gravitational forces driving deformation. We conclude that efficient drilling through thick, heterogeneous salt requires a holistic understanding of the mechanical and kinematic development of the salt and its overburden. This will also enable us to build better velocity models that account for intra-salt lithological and structural complexity in order to accurately image sub-salt geological structures.
-
-
-
The impact of heterogeneous salt velocity models on the gross rock volume estimation: an example from the Santos Basin pre-salt, Brazil
The thick and heterogeneous salt section in the Santos Basin, offshore Brazil, imposes great challenges in accessing the pre-salt hydrocarbon reservoirs, especially in relation to seismic imaging, signal quality and depth positioning. Some problems arise from the current velocity models for the salt section, which, for the majority, assume that the salt is a homogeneous halite layer. In the Santos Basin, the commonly assumed salt – halite – only makes up to 80% of the mineral in this section. The inclusion of other salts as stratification in the velocity models, based on seismic attributes, has achieved good results in the last decade, especially for depth resolution. In this work, we analyse the benefits of different velocity models, considering presence/absence of salt stratification and comparing the gross rock volume above the oil–water contact. The results show a significant effect on the depth resolution of the events, as well as on volume estimation, indicating that the greater the reliability captured by the complex velocity models, the greater the confidence in the resulting volumetric information.
-
-
-
Depositional conditions at the Aptian pre-salt margins: evidence from quantitative petrography and textural analysis of the Mucuri Member, Espírito Santo Basin, Brazil
Aptian siliciclastic onshore deposits of the Mucuri Member are important reservoirs in the Espírito Santo Basin (eastern Brazil). A detailed quantitative petrographical and textural analysis of well core samples was performed in order to unravel their depositional processes and conditions, in relation to previously proposed depositional models. The results allowed differentiation between two groups of sandstone samples, characterized by different textural characteristics associated to different depositional processes and environments within the Mucuri depositional system. Fluvial sandstones are represented by medium- to coarse-grained, poorly sorted arkoses, rich in plutonic rock fragments and feldspar grains, mainly transported by traction. Coastal-lacustrine sandstones correspond to very fine- to fine-grained, moderately sorted micaceous arkoses, mainly transported in suspension. The application of a discriminant function based on grain-size parameters validated previously proposed depositional settings for the studied sample groups. The combination of grain-size and shape data revealed differences in hydraulic equivalence and shape between grains from different depositional settings. In terms of hydraulic equivalence, micas in the fluvial sediments present lower settling velocity values, in contrast to the relatively large mica grains in the coastal sediments, which are hydraulically equivalent with the associated quartz and feldspar grains. The results of this study provide key information regarding depositional conditions (transportation mechanisms, grain-settling velocity and mineral hydraulic fractionation) at the margins of the Aptian pre-salt system, which can constrain the hydrological conditions and the sediment type available for distal lacustrine areas.
-
-
-
Quantification of solubility trapping in natural and engineered CO2 reservoirs
Secure retention of CO2 in geological reservoirs is essential for effective storage. Solubility trapping, the dissolution of CO2 into formation water, is a major sink on geological timescales in natural CO2 reservoirs. Observations during CO2 injection, combined with models of CO2 reservoirs, indicate the immediate onset of solubility trapping. There is uncertainty regarding the evolution of dissolution rates between the observable engineered timescale of years and decades, and the >10 kyr state represented by natural CO2 reservoirs. A small number of studies have constrained dissolution rates within natural analogues. The studies show that solubility trapping is the principal storage mechanism after structural trapping, removing 10–50% of CO2 across whole reservoirs. Natural analogues, engineered reservoirs and model studies produce a wide range of estimates on the fraction of CO2 dissolved and the dissolution rate. Analogue and engineered reservoirs do not show the high fractions of dissolved CO2 seen in several models. Evidence from natural analogues supports a model of most dissolution occurring during emplacement and migration, before the establishment of a stable gas–water contact. A rapid decline in CO2 dissolution rate over time suggests that analogue reservoirs are in dissolution equilibrium for most of the CO2 residence time.
Supplementary material: Dissolution rate for all plots and exponential function curves for scenarios A and B are available at https://doi.org/10.6084/m9.figshare.c.5476199
Thematic collection: This article is part of the Geoscience for CO2 storage collection available at: https://www.lyellcollection.org/cc/geoscience-for-co2-storage
-
-
-
Open fractures in pre-salt silicified carbonate reservoirs in block BM-C-33, the Outer Campos Basin, offshore Brazil
Natural open fractures are present in sidewall cores and in whole-core samples from pre-salt reservoirs in the licence block BM-C-33 in the Campos Basin, Brazil. Open fractures are also observed in borehole image logs, and fracture densities are in general high. The highest density of open fractures is seen in the damage zones above and below larger cavities (amalgamated cavern damage zones (ACDZs)). Outside the ACDZs the fracture density is high in silicified carbonates, where it tends to increase with decreasing porosity. Clean dolomites are less fractured than the silicified interval, while the less brittle argillaceous dolomites have the lowest fracture density. Some fractures appear vuggy on borehole image logs, and fracture densities are high close to vugs and larger cavities. The positive correlation between fractures and vugs is caused by flow of dissolving fluids through open fractures, and fracturing at stress concentrations around vugs. Two major fault zones have been interpreted from borehole image logs that have damage zones with very high fracture density. The well-test permeability is much greater than the matrix permeability estimated from sidewall core and log measurements. This excess permeability is attributed to fractures, in combination with caverns and intervals with frequent vugs.
-
-
-
Upscaling of outcrop information for improved reservoir modelling – exemplified by a case study on chalk
Authors Dongfang Qu, Peter Frykman, Lars Stemmerik, Klaus Mosegaard and Lars NielsenOutcrops are valuable for analogous subsurface reservoirs in supplying knowledge of fine-scale spatial heterogeneity pattern and stratification types, which are difficult to obtain from subsurface reservoir cores, well logs or seismic data. For petrophysical properties in a domain where the variations are relatively continuous and not dominated by abrupt contrasts, the spatial heterogeneity pattern can be characterized by a semivariogram model. The outcrop information therefore has the potential to constrain the semivariogram for subsurface reservoir modelling, even though it represents different locations and depths, and the petrophysical properties may differ in magnitude or variance. However, the use of outcrop-derived spatial correlation information for petrophysical property modelling in practice has been challenged by the scale difference between the small support volume of the property measurements from outcrops and the typically much larger grid cells used in reservoir models. With an example of modelling the porosity of an outcrop chalk unit in eastern Denmark, this paper illustrates how the fine-scale spatial correlation information obtained from the sampling of outcrops can be transferred to coarser-scale models of analogue rocks. The workflow can be applied to subsurface reservoirs and ultimately improves the representation of geological patterns in reservoir models.
-
-
-
Geology and petroleum prospectivity of the Sea of Hebrides Basin and Minch Basin, offshore NW Scotland
The Sea of Hebrides Basin and Minch Basin are late Paleozoic–Mesozoic rift basins located to the NW of the Scottish mainland. The basins were the target of small-scale petroleum exploration from the late 1960s to the early 1990s, with a total of three wells drilled within the two basins between 1989 and 1991. Although no commercially viable petroleum discoveries were made, numerous petroleum shows were identified within both basins, including a gas show within the Upper Glen 1 well in Lower Jurassic limestones. Organic-rich shales have been identified throughout the Jurassic succession within the Sea of Hebrides Basin, with one Middle Jurassic (Bajocian–Bathonian) shale exhibiting a total organic carbon content of up to 15 wt%. The focus of this study is to review the historical petroleum exploration within these basins, and to evaluate whether the conclusions drawn in the early 1990s of a lack of prospectivity remains the case. This was undertaken by analysis of seismic reflection data, gravity and aeromagnetic data, and sedimentological data from both onshore and offshore wells, boreholes and previously published studies. The key findings from our study suggest that there is a low probability of commercially sized petroleum accumulations within either the Sea of Hebrides Basin or the Minch Basin. Ineffective source rocks, likely to be due to low maturities (due to lack of burial) and the fact that the encountered Jurassic and Permian–Triassic reservoirs are of poor quality (low porosity and permeability), has led to our interpretation of future exploration being high risk, with any potential accumulations being small in size. While petroleum accumulations are unlikely within the basin, applying the knowledge obtained from this study could provide additional datasets and insight into petroleum exploration within other NE Atlantic margin basins, such as the Rockall Trough and the Faroe–Shetland Basin.
-
-
-
Quantitative seismic interpretation of the Lower Cretaceous reservoirs in the Valdemar Field, Danish North Sea
Authors Kenneth Bredesen, Mads Lorentzen, Lars Nielsen and Klaus MosegaardA quantitative seismic interpretation study is presented for the Lower Cretaceous Tuxen reservoir in the Valdemar Field, which is associated with heterogeneous and complex geology. Our objective is to better outline the reservoir quality variations of the Tuxen reservoir across the Valdemar Field. Seismic pre-stack data and well logs from two appraisal wells form the basis of this study. The workflow used includes seismic and rock physics forward modelling, attribute analysis, a coloured inversion, and a Bayesian pre-stack inversion for litho-fluid classification. Based on log data, the rock physics properties of the Tuxen interval reveal that the seismic signal is more governed by porosity than water-saturation changes at near-offset (or small angle). The coloured and Bayesian inversion results were generally consistent with well-log observations at the reservoir level and conformed to interpreted horizons. Although the available data have some limitations and the geological setting is complex, the results implied more promising reservoir quality in some areas than others. Hence, the results may offer useful information for delineating the best reservoir zones for further field development and selecting appropriate production strategies.
-
Volumes & issues
-
Volume 30 (2024)
-
Volume 29 (2023)
-
Volume 28 (2022)
-
Volume 27 (2021)
-
Volume 26 (2020)
-
Volume 25 (2019)
-
Volume 24 (2018)
-
Volume 23 (2017)
-
Volume 22 (2016)
-
Volume 21 (2015)
-
Volume 20 (2014)
-
Volume 19 (2013)
-
Volume 18 (2012)
-
Volume 17 (2011)
-
Volume 16 (2010)
-
Volume 15 (2009)
-
Volume 14 (2008)
-
Volume 13 (2007)
-
Volume 12 (2006)
-
Volume 11 (2005)
-
Volume 10 (2004)
-
Volume 9 (2003)
-
Volume 8 (2002)
-
Volume 7 (2001)
-
Volume 6 (2000)
-
Volume 5 (1999)
-
Volume 4 (1998)
-
Volume 3 (1997)
-
Volume 2 (1996)
-
Volume 1 (1995)